How to Use Ethernet Connectivity

From wizarPOS
Revision as of 17:06, 4 January 2024 by Simon (talk | contribs)

This guide provides instructions on how to enable Ethernet connectivity for Q1 and Q2 WizarPOS terminals.

Ethernet Support for Q1 Terminal

  1. Connecting the Ethernet Module:
    • Connect the Ethernet module to the Q1 terminal using an OTG-USB cable.
  2. Enabling Ethernet in Settings:
    • Navigate to 'Settings' > 'Ethernet' to enable the Ethernet connection.
    • Note for Older Firmware: If the 'Ethernet' menu is not available in your firmware version, you will need to obtain and install the Ethernet enable control APK. Once installed, run the APK and enable the Ethernet connection.

Ethernet Support for Q2 Terminal

  1. Acquiring the Ethernet Module:
    • To obtain an Ethernet module for the Q2 terminal, contact David Wang via email at david.wang@wizarpos.com.
  2. Enabling Ethernet in Settings:
    • Once the Ethernet module is connected, go to 'Settings' > 'Ethernet' to enable Ethernet connectivity.